Menvier Security SD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 17)

Remote Reset Number

The "Engineer Reset" option can be overridden by

the user, operating the "Remote Reset" facility. If

analarm is generated thesystemwill respond with

a four digit "seed" code which the user quotes to

the alarm company. The "seed" code is then

entered into a decoder and a unique "Remote

Reset" code is generated. This is passed back to

the user and, on entering the "Remote Reset"

code, the system will reset.

The "Remote Reset" code is generated using an

algorithm identified by a 3 digit number.

Alternative algorithms may be selected but these

must correspond to that used by the alarm

company otherwise the "Remote Reset" code will

be incorrect. The "Remote Reset" feature may be

disabled altogether by setting the number to

"000".

➤ To program the remote reset number

proceed as follows:

1. Ensure that the engineer’s menu is selected,

then press [8] to select remote reset number.

2. Zone LEDs 1 to 3 will now light.

3. As the new remote reset number is entered

each LED will go out one by one. When all 3

digits have been entered, LEDs 1 to 3 will light

again and the new number must be

re-entered for confirmation.

4. Ahighpitchedtoneindicates the new number

was excepted, a low pitched tone indicates

the number was incorrectly entered and the

procedure must be repeated.

System Options

There are six system options which change the

functionality of the alarm system. The options are

as follows:

Bell Output

Thebelltriggeroutput [TRG-] can be programmed

as either:

SAB: When programmed as SAB the output will

switch to 0V on alarm.

SCB: When programmed as SCB the output

providesa0Vholdoff,whichisremovedonalarm.

Setting Mode

The system can be programmed to set using

ether:

Timed Exit: The system will set when the exit timer

has expired.

Final Exit: The system will set when the last

detector or door contact is activated during the

exit procedure. Note: When the system is part set

(HOME)thesystemwillalwayssetbytimedexitand

is silent.

Reset Authority

Theperson responsible for resetting full alarmscan

be programmed as either:

User: Following a full alarm the system can be

reset by the user.

Engineer: Following a full alarm the system can

only be reset by the engineer or Remote Reset (If

enabled).

System Re-arms

The system can be programmed to re-arm after

an alarm. The re-arm options are:

1 re-arm: When an alarm occurs, the internal

andexternal sounders areoperated for thelength

of the bell duration. At the end of this time the

alarm is silenced and the all zones are re-armed.

Any zones that are active will be automatically

isolated until they return to their healthy state. If an

alarm occurs from the same zone it will cause the

internal and external sounders to operate again,

at the end of the alarm the zone is "Locked-out"

andpreventedfromgeneratinganotheralarm.All

other healthy zones will re-arm and will only be

‘Locked-out’ when they have caused another

alarm.

3 Re-arms: Operates as above, but zones are

only "Locked-out" after the system has re-armed 3

times.

TS400/TS410 Installation Instructions Programming

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commenti su questo manuale

Nessun commento

Menvier Security SD1 Manuale delle Istruzioni Pagina 17

Commenti su questo manuale