Menvier Security SD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 21)

Chart 2 - System Will Not Set

21

TS400/TS410 Installation Instructions Testing & Fault Finding

Enter 4 digit

engineer code and

then press 3 to select

walk test mode

Zone LED on and

Pulse Sounder.

No zone LED's on

and sounder is off.

Press to exit

Walk Test.

[0]

Press or

to part set

or full set the system.

[HOME]

[AWAY]

Remove control

panel cover and

disable the case

tamper.

Remove wiring from

AUX TAMPER

terminals and link

with a piece of wire

If the Tamper LED

remains lit, fit link

between TMP- and

H/O -

If Tamper LED goes

out there is an open

circuit within the

AUX TAMPER wiring.

If the Tamper LED

remains lit ,

disconnect the

battery.

If tamper LED goes

out the tamper on

the external siren is

open.

If the Tamper LED

remains lit, the

control panel is

faulty.

If the Tamper LED

goes out the

battery is faulty

Tamper LED on.

See Chart 1 on Zone

Faults

Deactivate all

detectors & contacts

(e.g. close doors

etc.)

1 2 ... 16 17 18 19 20 21 22 23 24

Commenti su questo manuale

Nessun commento