Menvier Security SD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 7)

The mains cable must enter the control

panel through its own cable entry and

must not be mixed with other cables.

3. Holdthecontrolpanelbackboxintherequired

position (keyhole to the top) and mark the

centre of the keyhole position. Remove the

back box, drill and plug the hole.

4. Screw a No 10 screw into the plugged hole.

Re-position the back box and mark the

remaining securing holes. Remove the back

box, drill and plug the holes.

5. Re-position the back box and pass all cables

intothebaseviacableentries,grommetingas

appropriate.

6. Securethe backboxusingnotless than30mm

x No 10 screws.

When replacing the cover, always

ensure that the earth bonding lead is

connected to the spade connection

inside the control panel.

Mains Connection

The mains supply is connected to a 3 way "Euro

Type" fused terminal block, which is fitted with a

200mA fuse. All electrical connections should be

carried out by a qualified electrician and must

comply with the current IEE regulations.

To comply with european regulations the

supply should be fed from a readily

accessible disconnect device, e.g.

un-switched fused spur fitted.

When making mains connections it should

be ensured that if the cable slips in such a

way as to place a strain on the conductors,

the protective earthing conductor will be

the last to take the strain.

Battery Connection

A suitable standby battery must be fitted to the

system to allow it to function during a mains fail

condition.TheTS400andTS410areequippedwith

a "Battery Protection" circuit so that if a battery is

accidentally reverse connected or its voltage is

below 4V, a tamper alarm is generated. To clear

the fault simply reconnect or replace the battery

as appropriate.

TS400/TS410 Installation Instructions System Installation

Fused

terminal block

(200mA)

Transformer

Spade connection

for earth lead to front

cover

Printed Circuit Board

(PCB)

Standby battery

7.0 Ah

Standby battery

2.1 Ah

Figure 2 TS410 Control Panel Assembly

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commenti su questo manuale

Nessun commento

Menvier Security SD1 Manuale delle Istruzioni Pagina 7

Commenti su questo manuale